Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Cooling Shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Cooling fan assembly
Identify the cooling fan assembly highlighted in blue.
Lift both release levers simultaneously to unlock the assembly.
Hold both release levers, and lift the assembly away from the system
Riser 1 assembly
Identify the expansion card riser 1 highlighted in blue
Pull the expansion card latch out of the slot.
Press the release latches, and lift the riser from the system board
Control panel -Right
Identify the control panel highlighted in blue
Disconnect the VGA cable from the system board.
Pull the cable latch and disconnect the control panel cable from the system board connector.
Using Phillips #1 screwdriver, remove the screws that secure the control panel assembly to the system.
Unroute VGA cable from the side wall of the system.
Holding the control panel assembly by its sides, remove from the system
Install
Control panel -Right
Identify the control panel location highlighted in blue
Route the control panel and VGA cable through the side wall of the system.
Align the right control panel assembly with the slot and slide into place
Connect the VGA cable to the system board.
Connect the cable to the system board connector and secure it using cable latch
Install the screws to secure the control panel to the system.
Riser 1 assembly
Identify the expansion card riser 1 location highlighted in blue
Align the riser with the standoffs and push the riser down until it snaps into place.
Push the expansion card latch
Cooling fan assembly
Identify the cooling fan location highlighted in blue.
Align the guide rails on the cooling fan assembly with the standoffs on the system
Lower the cooling fan assembly into the system
Press both release levers to lock the cooling fan assembly into the system
Cooling Shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.